Model 6000Model 6000FLOW-THROUGHFURNACE HUMIDIFIERInstallation/OperatingInstructions
OPTIONAL SETTING # 1 (FIG. 26.)Humidifier ON : A temperature rise of 4°Cin one minute and a temperature greaterthan 30°CHumidifier OFF: A temperature
1. MAIN ON/OFF POWER BUTTON FOR THE HUMIDIFIER. –Use this button only when turning ON or OFF the humidifier.2. REDUCE RELATIVE HUMIDITY SET POINT BUTT
(by the thermostat) the humidifier will cycle OFF – You willknow because the green “HUMIDISENSE” LED (fig. 23) on thefront of the humidifier will turn
FREQUENTLY ASKED QUESTIONSQUESTION: Why use a Flow Through Style Humidifier ratherthan a Drum Style humidifier?ANSWER: This will depend on several f
• READ THESE INSTRUCTIONS FULLY BEFORE INSTALLINGTHIS HUMIDIFIER.• SAVE THESE INSTRUCTIONS FOR REFERENCE.• WHEN DRILLING OR CUTTING INTO DUCTING BEEXT
1. The humidifier body is installed too low and will be difficult towork on.2. The humidifier body and bypass collar and damper are notlevel, This wi
1. The humidifier body is not mounted level on the duct, the waterwhich flows to the distribution tray and through the evaporatorpad will all run down
4. Gently re-direct the two red wires exiting the right hand sideof the digital humidistat top console so that they exit the topconsole from the left
6. Install the evaporator pad assembly by hooking the slanted tabson the Evaporator Pad Frame onto the tabs on the back of thehumidifier cabinet. MAK
4. Select the most convenient location for connecting the selfpiercing needle valve, On a cold water pipe. Connect theneedle valve as shown (fig 19)
6. Once the unit has been running for approx 3-4 minutes youwill see a small amount of water trickling out of the drain tube.If the unit has turned on
Commentaires sur ces manuels