Air King AKLC702 Manuel d'instructions télécharger pdf (Page 3)

NOTE: If the fan motor plug is

connected to the fan housing

receptacle, unplug so the

blower assembly can be

completely removed.

2a. Wiring Fan/Light Independently: Run wiring from an approved

wall switch carrying the appropriate rating. One neutral

(white), one ground (green or bare copper), and two hot

(black lead connected to the switch). Secure the electrical

wires to the housing with an approved electrical connector.

Make sure you leave enough wiring in the box to make the

connection to the fan’s receptacle.

2b. From where you have access to inside the fan’s junction box,

connect the one white wire from the house to both the white

wire from the fan’s light receptacle and the white wire from

the fan’s exhaust receptacle. Connect the first black wire

from the wall switch to the red wire from the fan’s light

receptacle. Connect the second black wire from the house

to the fan’s exhaust receptacle. Connect the ground wire

from the house to the green wire from the fan’s grounding

screw (Figure 9). Use approved methods for all connections.

3a. Wiring Fan/Light together: Run wiring from an approved wall

switch carrying the appropriate rating. One neutral (white),

one ground (green or bare copper), and one hot (black lead

connected to the switch). Secure the electrical wires to the

housing w ith an approved electrical connector. Make sure

you leave enough wiring in the box to make the connection

to the fan’s receptacle.

3b. From where you have access to inside the fan’s junction box,

connect the one white wire from the house to both the white

wire from the fan’s light receptacle and the white wire from

the fan’s exhaust receptacle. Connect the black wire from

SECTION 4

Ducting

CAUTION: ALL DUCTING MUST COMPLY WITH LOCAL

AND NATIONAL BUILDING CODES.

1. Connect the ducting to the fan’s duct collar (Figure 5). Secure

in place using tape or screw clamp. Always duct the fan to

the outside through a wall or roof cap.

NOTE: If damper detaches from unit, reattach by snapping the

collar back onto the unit. It is designed to only fit one way.

SECTION 5

Wiring

CAUTION: MAKE SURE POWER IS SWITCHED OFF AT

SERVICE PANEL BEFORE STARTING INSTALLATION.

CAUTION: ALL ELECTRICAL CONNECTIONS MUST BE

MADE IN ACCORDANCE WITH LOCAL CODES, ORDINANCES,

OR NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR

WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE

THE SERVICES OF A QUALIFIED ELECTRICIAN.

NOTE: This unit includes a side access panel for wiring that does

not require the removal of the fan’s blower assembly. If you

choose to wire the unit from the inside, you will need to remove

the blower assembly and internal wiring compartment. Both

methods are equally effective.

1a. External Wire Compartment: Remove the wire compartment

cover screw and place cover in a secure place (Figure 6).

1b. Internal Wire Compartment: Remove the screw holding the blower

assembly in place. Lift up on the assembly and tilt it at a 45° angle

to remove from the housing (Figure 7). Remove the wire compartment

cover screw and place the cover in a secure place (Figure 8)

www.airkinglimited.com

210572200 Rev. A 6-06 3 of 12

Figure 5

Figure 7

Plug

Screw

Figure 6

Screw

Wire

Compartment

Cover

Figure 8

Screw

Wire

Compartment

Cover

Figure 9

Ground

Hot (Red)

Supply

from

house

White

Hot

(Black)

1 2 3 4 5 6 7 8 ... 11 12

Commentaires sur ces manuels

Pas de commentaire

Air King AKLC702 Manuel d'instructions Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Non Air King AKLC702