Air King AD1308 Guide de dépannage télécharger pdf (Page 2)

www.airkinglimited.com

6728001 Rev. D 4-08

INSTALLATION INSTRUCTIONS

1. Unpack hood from the carton and confirm that all pieces are present.

In addition to the range hood you should have:

1 - Aluminum Grease/Charcoal Filter

4 - #8 Mounting Screws

1 - Wire Compartment Cover and Screw

1 - Instruction/Safety Sheet

2. Lay the hood flat on a table so the underside is facing you. Use a

piece of cardboard to avoid damaging the table or the hood.

3. Remove lamp cover by squeezing the two tabs together (Figure 1).

4. Install a 60 watt maximum type A19 bulb and reinstall the lamp cover.

Prepare the location for Hood Support

1. If the hood will be installed under cabinets that have a recessed

bottom, it will be necessary to install wood mounting strips (not

included) so the hood will mount properly (Figure 2).

2. The thickness of the strips should be the same as the recess of the

cabinet and they should be approximately 2" wide.

3. Install the strips using appropriate length wood screws (not included).

Make sure the strips line up to the keyhole slots of the range hood.

Prepare the Hood for Installation

1. Determine where the electrical service will enter the hood and

remove the appropriate electrical knockout by inserting a screw

driver into the slot and rocking back and forth until the knockout

comes loose (Figure 3).

CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE

PANEL BEFORE STARTING INSTALLATION.

Installing the Range Hood

1. Once the proper knockout(s) have been removed, either hold the

hood up to the installation location and mark the locations of the

ducting (if applicable), electrical, and mounting holes or mark the

locations by measurement.

2. Cut appropriate holes for ducting connection (if applicable) and

electrical connection in the wall/cabinet.

3. Install an approved wire connector to the electrical knockout of

the hood and guide the electrical cable through the hood, allowing

at least 6" of wire for connections and tighten.

4. Install the 4 mounting screw at the previously marked locations.

Leave approximately 1/8" clearance. Slide the hood in place through

the keyhole slots and align the front of the hood so that it is flush with

the front of the cabinets. Tighten all screws securely (Figure 4).

Wiring

CAUTION:

ALL ELECTRICAL CONNECTIONS MUST BE MADE

IN ACCORDANCE WITH LOCAL CODES, ORDINANCES, OR NATIONAL

ELECTRICAL CODE. IF YOU ARE UNFAMILIAR WITH METHODS OF

INSTALLING ELECTRICAL WIRING, SECURE THE SERVICES OF A

QUALIFIED ELECTRICIAN.

1. Connect the 2 loose White wires from the range hood to the White

wire from the supply, and the loose Black wire from the range hood

to the Black wire of the supply. Connect the ground wire (green or

bare) from the supply to the green ground screw of the hood. Use

approved methods for all connections (Figure 5).

1/8"

Keyhole

Wood Strip

Figure 2

Figure 4

Figure 3

Tabs

Figure 1

1 2 3 4 5 6 7 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Air King AD1308 Guide de dépannage Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Non Air King AD1308